| SPECIFICATIONS |
| Model Capacity |
UPSU01
1KVA(1000VA)
(36V DC) |
UPSU03
3KVA(3000VA)
(96V DC) |
|
| Voltage |
| Frequency |
| Power factor |
|
| 150V-275V |
|
| 50±5% |
|
| >0.95 conforms to EN 605552 |
|
|
| Voltage |
| Phase |
| Regulation |
| Frequency |
| Power factor |
| Waveform Distortion |
| Crest factor |
| Overload capacity |
| Inverter Efficiency |
|
| 220 VAC ± 3% |
|
| 1 phase 2W + G |
|
| ±1% at linear load |
|
| 50Hz±0.5% |
|
| 0.7 |
|
| Pure sinewave less than 3% at full load |
| 3:1 |
|
| >105% for 10 sec. |
>110% for 200 msec. |
| >93% |
|
|
| Battery Built - in |
|
| 3x12V-7AH |
8x12V-7AH |
| 4 -8 hrs. 90% after fully discharge |
|
| Transfer Time |
| Bypass to UPS |
| UPS to Bypass |
|
|
|
| Multi-function |
| LED Display |
| LCD Display |
| |
|
| Line, Inverter, Bypass, Fault, Battery Load Level |
| |
| Output Frequency/Voltage, Input Frequency/Voltage |
| Load percentage, Battery percentage (Optional) |
|
|
| 1. AC Failure |
| 2. Battery low |
| 3. UPS Fault |
|
| Sounds every 4 seconds after line fails |
| Sounds every second when approaches level |
| Continuous alarm |
|
|
| Over/Under voltage at I/P |
| |
| Short circuit & Overload |
| |
| |
| |
|
| Yes |
| |
| |
| The UPS shuts down and will not transfer to the bypass when short circuit occurs on the output of the unit. After rectification of short circuit, the UPS operates normally again. At short condition, the Fault LED lights as a warning. |
| Lighting:Yes Surge:Yes |
|
|
| Temperature |
| Humidity |
| Audible Noise |
|
| 0°C to 40°C |
| 0 to 95% at non condensing |
| <45 dB at 1 metre |
|
| Connection |
Interface Port |
RS-232 connector |
Interface
Software |
Power Status, UPS Shutdown, Moniter UPS Status, UPS Self Test |
| Dimensions |
HxWxD (mm) |
|
Since product innovation is a continuous process at Elent, specifications are subject to
change without notice |
